Thread: Boost Gauge
08-09-2005, 06:53 AM #1
Any recommendations on where to purchase a boost gauge and the best type for our Doo's?
08-09-2005, 08:27 AM #2
I use an Autometer ATM-4376
It has highest boost recall and is resettable. The needle is very steady under boost.
08-09-2005, 08:41 AM #3
Is the only connection needed for operation to simply plug it into the boss that the BOV uses?
08-09-2005, 09:09 AM #4
Yea, a tube runs from the boss to the MAP sensor that comes with the gauge and then you hook up a (+) and a (-) wire from the MAP sensor.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Mark S in forum 4-Tec PerformanceReplies: 45Last Post: 04-17-2006, 09:59 PM
By Red Devil in forum 4-Tec PerformanceReplies: 15Last Post: 02-27-2006, 09:43 AM
By naorav in forum 4-Tec PerformanceReplies: 3Last Post: 11-24-2005, 08:33 AM
By spidercraft23 in forum 4-Tec PerformanceReplies: 2Last Post: 10-01-2005, 09:13 PM
By Kinchyle in forum 4-Tec PerformanceReplies: 59Last Post: 09-30-2005, 10:09 PM