Thread: Ultra 250 ODI grip install
02-10-2007, 02:05 PM #1
Ultra 250 ODI grip install
I'm not a big fan of the curved grips used on the kawi. So I changed them out to ODI Rogue grips.
I had to cut the bar ends off. If you are looking to replace the bar, be advised that it is a standup-style bar. The grips are vulcanized rubber, so a razor works. You can heat them, or just peel them off. The switch housing and throttle are screwed on. The cover is screwed on, then captured on a back piece. The buzzer goes inside the foam.
02-10-2007, 02:07 PM #2
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By ercoach in forum Polaris Open DiscussionReplies: 2Last Post: 07-19-2007, 10:20 AM
By B58FURY in forum Yamaha PWC Performance (2-stroke)Replies: 2Last Post: 06-18-2007, 07:16 AM
By B58FURY in forum Kawasaki Open DiscussionReplies: 0Last Post: 06-17-2007, 09:21 PM
By Hydrotoys in forum Kawasaki Tech Tips and InfoReplies: 0Last Post: 02-23-2007, 01:48 PM
By Therock in forum 4-Tec PerformanceReplies: 18Last Post: 05-31-2005, 12:48 PM