03-17-2010, 10:42 AM #1
- Join Date
- Sep 2009
Spark plug wire pulled loss from boot
When I installed the seat on my ski the vent tube must have caught the #1 spark plug wire and pulled it out of the boot. I looked and the parts breakd0wn and saw that the boot and the coil and wire are two seperate parts. Can I reinstall the boot and re ty-wrap?
03-17-2010, 10:46 AM #2
yes, cut back the plug wire just a bit too get a little of the copper showing..just a little bit though.. then install the boot and zip tie it good.. make sure the wire is connected too the metal piece in the boot or you will not have spark
03-17-2010, 05:19 PM #3
- Join Date
- Oct 2006
- Cleveland OH
Yes. Clip about 1/4" off the wire.
Screw the boot back onto the wire and re ziptie. That's it.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By CRAZEDRXP in forum Sea Doo Open DiscussionReplies: 19Last Post: 03-06-2008, 03:41 PM
By earthshaker in forum Kawasaki PWC Performance (4-stroke)Replies: 17Last Post: 11-04-2007, 07:37 AM
By VetteTech81 in forum 2-Stroke PerformanceReplies: 8Last Post: 11-01-2007, 11:54 PM
By ph2ocraft in forum Polaris Open DiscussionReplies: 2Last Post: 11-01-2007, 07:01 PM
By qbzonk in forum Yamaha PWC Performance (2-stroke)Replies: 5Last Post: 09-04-2006, 11:27 PM