Results 1 to 2 of 2
  1. #1

    Join Date
    Jul 2009
    Location
    Northern Indiana
    Posts
    11

    Question 1050 Static Timing Specs Needed

    Does anyone have the Steps to perform static timing when you install the upgraded ignition.

    What's the measurement of the piston btdc?

    What's the timing btdc at 3k rpm?

    I asked a couple weeks ago on another forum and was told to come here for help.

    Thanks


  2. #2
    casey67's Avatar
    Join Date
    Sep 2006
    Location
    Lemont,IL
    Posts
    2,571
    +1
    35
    Welcome to Green Hulk !
    If you do not mess with the screws on the front of the flywheel,you should be pretty good. But as always you should check the timing.

    18degree @ 3k rpm(+or- 2deg) .0815 inches- 2.07mm . 11deg @ 6250

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. 1050 Static Timing
    By kl7741 in forum Polaris Open Discussion
    Replies: 6
    Last Post: 10-02-2015, 08:34 AM
  2. Replies: 10
    Last Post: 01-06-2015, 07:37 PM
  3. 1999 1050 cdk II float height and pop off pressure specs needed
    By FloridaEdd in forum Polaris PWC Performance
    Replies: 3
    Last Post: 08-14-2014, 05:03 PM
  4. Replies: 2
    Last Post: 04-29-2013, 05:26 AM
  5. What do i need to make a static timing tool?
    By shelby427uk in forum Polaris Open Discussion
    Replies: 7
    Last Post: 07-24-2008, 09:53 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •