Thread: how many rpm's
08-10-2005, 07:28 PM #1
how many rpm's
my 04 rxp with a stage 1 kit is only turning 7700 rpm, is that normal? my top speed at 1650ft and 93 degrees was only 65 mph. I did notice a whole lot of cavitation out of the whole and am ready for an aftermarket impellar, any suggestions on what might work the best? I may also change my ecu if it is worthwhile
08-10-2005, 07:37 PM #2
I think if you install a new wear ring and a Solas 14/19 impeller you will be extremely pleased with your results.
08-10-2005, 09:04 PM #3
The riva stage 1 should have come with a solas 14/19 prop, and top loader grate also....is it a riva kit?
08-10-2005, 09:07 PM #4
You shouldn't have any cavitation unless your wear ring is worn out , or your carbon seal is wearing down.....how many hrs do u have?
08-11-2005, 11:54 AM #5
I have 55 hrs and already replaced the sp clutch with the stock set up, I did put on the riva blow off valve. I may have sucked up some debris in my pump so I do plan on pulling it over the weekend to check the impellar and wear ring. it is a riva stage one and the previous owner installed the kit so I'm not sure if the impellar was replaced at that time or not. what rpm's should I be turning?
08-11-2005, 12:11 PM #6
You need to shoot for 8000-8100
08-11-2005, 05:06 PM #7
65 MPH!? Is it just me or is that speed with the riva stage 1 a little low?
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By damo.r in forum 4-Tec PerformanceReplies: 5Last Post: 03-18-2009, 12:50 AM
By Ultra250xryder in forum Kawasaki PWC Performance (4-stroke)Replies: 6Last Post: 10-28-2007, 07:30 PM
By WATER WOODY in forum Yamaha PWC Performance (2-stroke)Replies: 21Last Post: 08-24-2006, 03:44 PM
By YudLuz2 in forum Yamaha PWC Performance (2-stroke)Replies: 10Last Post: 04-27-2006, 06:37 AM
By Jrsrxp in forum 4-Tec PerformanceReplies: 5Last Post: 08-02-2005, 07:27 PM