Thread: keyway question
03-28-2010, 01:07 PM #1
can it be installed with out removing the motor?
03-28-2010, 01:20 PM #2
but i dont think its worth the grief and cuts to hands and F words used..
WFO does it in hull but he has had special swivel wrist + elbow joints fitted in his right arm for this job...
03-28-2010, 01:23 PM #3
03-28-2010, 01:54 PM #4
I have done it in the hull quit a few times its not a big deal. Just get a 1 1/16" end wrench on the intermediate shaft and a puller on the flywheel.
03-28-2010, 02:02 PM #5
im gonna go for it!
as sitting on the ski with keyway up @ top does the shift go to the left or right?
im already a comp tard , dont wanna tard my ski
03-28-2010, 02:16 PM #6
To the right , looking at it.
Don't forget to support the front of the motor, and use some towels to pad the hull when removing the flywheel.
03-28-2010, 02:30 PM #7
03-28-2010, 03:53 PM #8
the way i understand it is if im sitting on the ski - offset is to the left
03-28-2010, 05:20 PM #9
considering how easy pulling the motor is, i just do that if you have the capability and tools to do so. Especially if you're not familiar with the parts in and around the stator cover. Or try it in the boat and if it starts to get shady then pull the engine.
03-28-2010, 07:06 PM #10
the hardest part was the mag cover bolts
im @ the 1/2 way mark gonna go get more beer and finish up
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By vomitspot in forum Yamaha PWC Performance (2-stroke)Replies: 8Last Post: 01-20-2008, 03:42 PM
By Tanny in forum Yamaha PWC Performance (2-stroke)Replies: 12Last Post: 01-16-2008, 01:34 PM
By slow1300 in forum Yamaha PWC Performance (2-stroke)Replies: 9Last Post: 06-30-2007, 04:10 PM
By w/rpm500 in forum Yamaha PWC Performance (2-stroke)Replies: 2Last Post: 08-07-2006, 05:49 AM
By backwash in forum Yamaha PWC Performance (2-stroke)Replies: 6Last Post: 03-15-2006, 01:49 PM