Thread: Plate angle
04-04-2010, 01:29 PM #1
Old skool guys,
On the R&D GP rideplate, can someone who has the Group-k cut on their plate measure.....
What and where the angle is cut into the rear most section of their plate..??
This is something i can easily cut myself, just don't want to cut too much off the sucker..
The big plan is cut the angle and true the ride plate surface..
All before i start to mess with shims..
04-04-2010, 07:09 PM #2
If I remember right it is 3,3,3
3* degrees on the mounting boss then 3 inches from the back of the plate you cut 3* from the flat portion of the plate.
04-04-2010, 07:25 PM #3
04-04-2010, 08:35 PM #4
I cut across both the front and rear bosses, just a slight clean up on the front. This way you have better contact area when you bolt it up.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Mik72e in forum Yamaha PWC Performance (2-stroke)Replies: 21Last Post: 09-15-2007, 06:04 PM
By jpa1300 in forum Yamaha PWC Performance (2-stroke)Replies: 6Last Post: 08-11-2007, 10:05 AM
By OCFZR in forum Yamaha How To & FAQsReplies: 2Last Post: 04-29-2007, 11:55 AM
By ChewsteR in forum Yamaha PWC Performance (2-stroke)Replies: 28Last Post: 04-14-2007, 10:48 PM
By 97GPSLEEPER in forum Yamaha Old School SkisReplies: 12Last Post: 01-08-2007, 08:29 PM