Thread: RXT Riva exhaust
04-08-2010, 07:56 AM #1
RXT Riva exhaust
Ok maybe I am missing somthing. But I put the template on the back of the ski drilled the hole for the exhaust and it is right in the center of the steering arm that goes to the fin on the side. wtf? I made sure I used the proper tamplate I did. Now what? Is this correct? If it is how the hell does the exhaust get hooked up to the outlet?
04-08-2010, 08:00 AM #2
Im pretty sure Riva recommends that you remove OPAS before doing that bro.
Just take them out and get you some blockoffs since you have already begun.
04-08-2010, 08:44 AM #3
04-08-2010, 08:56 AM #4
- Join Date
- Aug 2007
- Reading PA
Yes Riva says u have to remove the Opas to use the Thru hull setup, but it can be run with OPAS system, u have to ditch the template and line it up yourself and do the baseball bat trick where the pipe hits the seat cowling, have to put a little dent into it so it doesnt rub, I have seen it done on one RXT like that and i have seen a GTI with Thru hull with Opas still on.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Pinoy in forum 4-Tec PerformanceReplies: 24Last Post: 04-19-2008, 09:39 AM
By JordanHaye in forum 4-Tec PerformanceReplies: 2Last Post: 06-06-2007, 07:45 PM
By VaRedneck in forum 4-Tec PerformanceReplies: 7Last Post: 03-22-2007, 06:42 PM
By LAB69 in forum 4-Tec PerformanceReplies: 3Last Post: 02-01-2007, 07:59 PM
By R-Doo in forum Sea Doo Open DiscussionReplies: 2Last Post: 11-14-2006, 03:34 PM