04-13-2010, 11:30 PM #1
Post up your Old School porn pics
I'll start this is a sweet one
6mm stroked Billet crank
Dan Lamey fabricated cylinders, 81mm bore +3mm in height. Cylinder made to accept power valves but not machined into this set.
Post up your best motor porn
04-14-2010, 07:59 AM #2
The OC GP1200 motor, hey Peavler recognize anything?
04-14-2010, 08:28 AM #3
Something to hold it down and keep it steady
04-14-2010, 09:02 AM #4
Got to feed the beast
Fuel delivery? what to feed a beast?
04-14-2010, 10:07 AM #5
Here are some pics, not quite XXX but will get the job done.
48 novis with vf-3 reeds and prok f/a's
04-14-2010, 10:09 AM #6
Pump & Pipes
skat-trak 155mm E-75 12 vane magnum pump.
Factory triple pipes powder coated red.
with some old 46mm buckshots.
04-14-2010, 10:12 AM #7
Some case porting too bad I dont have any good cyl pics but just a standard Team Butch porting. The sleeves were cut a bit to open up the intake too.
04-14-2010, 10:15 AM #8
Here are some more pics of that rare fluid dampner by vibratech.
Before and after I cleaned it up. I dont know why the pics show white but it is polished.
04-14-2010, 10:25 AM #9
These carbs need to drink and dont want any air.
Novi fuel/air seperator, 3 - 65lph mikuni fuel pumps, triple fuel pickup.
04-14-2010, 10:26 AM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By codymouse54321 in forum Yamaha PWC Performance (2-stroke)Replies: 7Last Post: 11-15-2007, 09:01 PM
By breon in forum 4-Tec PerformanceReplies: 10Last Post: 10-21-2007, 08:59 PM
By MIARider in forum Sea Doo Open DiscussionReplies: 2Last Post: 09-04-2007, 02:17 PM
By peter in forum Sea Doo Open DiscussionReplies: 1Last Post: 07-30-2005, 02:52 PM
By nitro rxp in forum Sea Doo Open DiscussionReplies: 1Last Post: 07-03-2005, 01:21 AM