04-14-2010, 06:03 AM #1
66V Big Bore Head & 6 degree nozzle
175 for the head - It was cut to use 87mm pistons and run about 120psi. It has a special dome cut to help elleviate detion.
40 for the nozzle - it is a 6 degree nozzle that has been drilled and tapped for the reverse bucket if needed. The water spout has been plugged but could be drilled out if needed.
Paypal to email@example.com for the quickest shipment.
04-14-2010, 07:08 AM #2
- Join Date
- Mar 2010
I'll take the 6 degree nozzle...I'll send the money today via paypal, if you still have it
04-14-2010, 02:57 PM #3
Who cut the head
Do you know who cut the head and the octane needed?
04-17-2010, 01:01 PM #4
04-17-2010, 09:01 PM #5
Pay pal sent
Money sent for the head.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By beerdart in forum Yamaha Open DiscussionReplies: 3Last Post: 09-13-2007, 02:03 PM
By Gappa in forum 2-Stroke PerformanceReplies: 1Last Post: 09-04-2007, 08:19 PM
By J-ME in forum Yamaha PWC Performance (2-stroke)Replies: 13Last Post: 11-11-2006, 07:54 AM
By CarFanatic in forum 4-Tec PerformanceReplies: 3Last Post: 06-08-2006, 07:29 AM
By PAINKILLER in forum 4-Tec PerformanceReplies: 43Last Post: 03-09-2006, 06:53 PM