Results 1 to 3 of 3

Thread: 1999 gp1200

  1. #1

    1999 gp1200

    I have a gp1200 with about 125hrs. Last summer the oil line that feeds the #3 cylinder came off. I tore the ski down and found damage to the cylinder and piston. Is it possible to just bore this cylinder and install oversize piston and rings? Leaving the other two cylinders stock. Thanks for any help.

  2. #2
    Join Date
    Apr 2006
    Orange, TX
    It is possible, but not recommended. I would either have it resleeved, or bore all three. You will cause extra wear on the crank bearings having a bigger piston on one cylinder. Also, go premix from here on out.

  3. #3
    thanks for the info

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. 1999 gp1200 prop help
    By MAESTRO.RACING in forum Yamaha PWC Performance (2-stroke)
    Replies: 7
    Last Post: 04-03-2009, 09:38 AM
  2. 1999 GP1200 Engine Full of Water
    By anieve in forum Yamaha Open Discussion
    Replies: 15
    Last Post: 08-31-2008, 08:54 PM
  3. Clean 1999 GP1200 with 63 hours
    By NCRXP in forum Yamaha 2 Stroke Skis
    Replies: 4
    Last Post: 08-23-2008, 10:51 PM
  4. Clean 1999 GP1200 with 63 hours
    By NCRXP in forum Yamaha Classifieds
    Replies: 2
    Last Post: 07-31-2008, 09:39 PM
  5. is this apdesigns for a 1999 gp1200?
    By jeff007 in forum Yamaha PWC Performance (2-stroke)
    Replies: 6
    Last Post: 07-30-2007, 11:59 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts