04-15-2010, 03:15 PM #1
Impeller Housing Milling For Plastic Wear Ring
Can some give me some insight as to what needs to be milled for the plastic wear ring to replace the stainless steel ring?
I assume the OD of the plastic wear ring is larger than the OD of the SS ring?
04-15-2010, 03:26 PM #2
it is. PM inkaddict. he had a few done and may have one kicking around. it would take a fixture and a good lathe to hold it true, and you have to cut the stainless pretty slow because of the diameter.
04-15-2010, 06:58 PM #3
From the sounds of your post, the SS ring stays in? I was trying to look at as many pictures as possible, and then I was going to take measurements and go from there.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Autosport in forum Yamaha PWC Performance (2-stroke)Replies: 20Last Post: 12-26-2007, 09:42 AM
By doc212121 in forum 4-Tec PerformanceReplies: 2Last Post: 09-20-2007, 03:39 PM
By thebert in forum Yamaha Open DiscussionReplies: 1Last Post: 04-24-2007, 12:54 AM
By qbzonk in forum Yamaha PWC Performance (2-stroke)Replies: 3Last Post: 04-17-2007, 09:48 AM
By Troy Hammond in forum Yamaha PWC Performance (2-stroke)Replies: 1Last Post: 07-08-2006, 02:05 PM