Results 1 to 2 of 2
  1. #1

    will a plastic busing in the sterring nozzle?

    Will this cause bad peformance and bad handling. I pulled the pump today to change out the wear ring and noticed that the plastic bushing that goes on the nozzle is gone and its just moving around no other.

  2. #2
    what bushing?

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. absolutely, positively, will not go WOT in the water!
    By Octoarms in forum Polaris Open Discussion
    Replies: 6
    Last Post: 05-04-2015, 04:04 PM
  2. Why are there 2 allen headed bolts in the steering nozzle 98 1100stx
    By JSPowersports in forum Kawasaki Open Discussion
    Replies: 0
    Last Post: 07-03-2011, 12:24 PM
  3. Help identify this plastic screw I found in the engine bay?
    By Old Atari Nut in forum Polaris Open Discussion
    Replies: 3
    Last Post: 07-12-2008, 09:48 PM
  4. Will the Skat Trak venturi rings fit the Riva nozzle ?
    By DaveC in forum 4-Tec Performance
    Replies: 2
    Last Post: 08-18-2007, 03:19 PM
  5. Are sharks plastic fins in the pump support needed
    By macattack in forum 4-Tec Performance
    Replies: 0
    Last Post: 07-04-2005, 11:50 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts