Results 1 to 2 of 2
  1. #1

    bilge install question

    Do I need to run a high pressure water hose from the pump to the through hull exit like the engine pisser water lines, or will any water hose (clear plastic) be ok? It is a rule 500gph.

    Thanks


  2. #2
    WATER WOODY's Avatar
    Join Date
    Aug 2005
    Location
    Minden, Nevada, United States
    Posts
    10,664
    +1
    11
    The bilge line does not need to be high pressure. The OEM thinner hose is alot more flexible and easier to route. If thats all you have is high pressure line then you can use it if needed just not necessary

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. RXP bilge pump install question
    By sea-one in forum Sea Doo Open Discussion
    Replies: 2
    Last Post: 11-18-2009, 08:33 PM
  2. RXP bilge pump install question
    By sea-one in forum Open Discussion
    Replies: 0
    Last Post: 11-18-2009, 07:14 PM
  3. RR ECU Install questions
    By Vern in forum 4-Tec Performance
    Replies: 11
    Last Post: 07-09-2005, 09:59 AM
  4. Pump install question.
    By Mark S in forum 4-Tec Performance
    Replies: 2
    Last Post: 07-01-2005, 09:25 PM
  5. '05 RXT/GTX RR IC install question... O-ring?
    By 05Limited in forum 4-Tec Performance
    Replies: 5
    Last Post: 06-03-2005, 09:54 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •