Thread: MSX 150 intake manifold removal
04-28-2010, 07:51 AM #1
MSX 150 intake manifold removal
I got the 4 bolts out the go to the motor and the one bolt on the bottom coner towards the motor. I cant seem to find these other two bolts on the bottom they are talking about that are on the right hand side of the hull. Is there something else I need to take off to see them? The manual just says remove bolts and take off intake.
04-28-2010, 08:40 PM #2
I just got it off but wow I really hope I did it the hard way because that was a huge pain. I somehow got those two back bolts out then I still had to jam it towards the rear till it cleared everything then reach through the front and pull it out just like the intercooler.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By 74mjh in forum 4-Tec PerformanceReplies: 9Last Post: 04-08-2008, 08:21 PM
By kman in forum Kawasaki PWC Performance (4-stroke)Replies: 8Last Post: 03-11-2008, 09:27 PM
By jcc011185 in forum Kawasaki Open DiscussionReplies: 32Last Post: 09-12-2007, 10:01 PM
By fast1983 in forum Polaris PWC PerformanceReplies: 1Last Post: 05-27-2007, 07:05 PM
By superd in forum Yamaha Old School SkisReplies: 14Last Post: 09-11-2006, 09:03 PM