05-02-2010, 08:06 PM #1
- Join Date
- May 2010
Just bought a '96slx 780 and the lo pwr keeps flashing can any one hepl with this... its the 1st pwc i've owned and very new to this.
05-02-2010, 08:35 PM #2
Welcome to Green Hulk ! And Polaris !
Measure the Battery volts with a meter when it's running,it needs to be atleast 13.5v or so.
If the voltage is OK ,than the display needs to be reset/calibrated. That info is listed on this site,use the search function.
05-02-2010, 08:46 PM #3
- Join Date
- Jul 2007
- near Toronto, Canada
As others have said, check the actual battery voltage using a multi-meter. Engine off, just sitting for more than a few minutes, it should be about 12.5 volts, sometimes a little higher.
Engine running, it should be about 14.x volts, definitely above 13.5 volts.
Sometimes the MFD needs to be 'Calibrated', and sometimes the problem is related to a corroded or poor electrical connection.
Open the electrical box, and make sure it is dry inside, and there is zero corrosion present. Pay particular attention to the Black wires, and the fuses.
If that is all good, then try the MFD calibration;
Multi-Function Display (MFD)
05-02-2010, 10:44 PM #4
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)