Thread: Supercharger Tool?
05-03-2010, 04:10 PM #1
What specialty tools are needed to service a SD Supercharger, change clutch washers etc?
05-03-2010, 04:30 PM #2
Troy, to just change the washers you will want these two tools
RIVA Sea-Doo Supercharger Shaft Holder Tool
Our Sea-Doo Supercharger Shaft Holder Tool makes servicing your supercharger a snap. Ergonomically designed billet handle allows a sure, firm grip...
Sea Doo part number 529 035 947
This tool is recommended to hold the gear when checking slip
Gear Holder Tool
Sea Doo part number 529 036 025
If you are going to do a full rebuild then you will also want these two tools
Sea Doo part number 529 035 950
Four Pin Socket
Sea Doo part number 529 035 948
05-03-2010, 04:38 PM #3
Thanks Jerry. Not really sure what I am going to do. I think it is just slipping a little. I have a new SC wheel and other goodies, but I am still having fun with it as it is now. I am going to ride tomorrow to see if it is still acting up. Probably just send it to you.
05-03-2010, 04:39 PM #4
I know you have more money than time.
Just send it to Jerry and be done with it.
05-03-2010, 04:40 PM #5
05-03-2010, 04:50 PM #6
Is it possible to check slip with the SC still in the ski?
05-03-2010, 04:57 PM #7
05-03-2010, 04:59 PM #8
05-03-2010, 05:07 PM #9
The problem is keeping the motor from spinning
05-06-2010, 10:52 AM #10
Can someone explain how to use the "shaft holder tool? I have the tool, changed my washers and didn't use the tool let alone know how it is used?
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By XPChris in forum Sea Doo Open DiscussionReplies: 4Last Post: 04-08-2008, 09:56 PM
By Green Hulk in forum 4-Tec PerformanceReplies: 31Last Post: 10-09-2007, 10:17 AM
By Green Hulk in forum 4-Tec PerformanceReplies: 4Last Post: 09-07-2007, 11:43 AM
By Green Hulk in forum 4-Tec PerformanceReplies: 18Last Post: 04-06-2007, 08:38 AM
By Green Hulk in forum 4-Tec PerformanceReplies: 11Last Post: 09-09-2006, 10:47 AM