Thread: Cylinder Head Port Threads?
05-04-2010, 09:17 AM #1
Cylinder Head Port Threads?
anybody know what the threads are on the port we use to feed the Turbo applications??
parts finder says M10, but M10 x 1.0, M10 x 1.25 or M10 x 1.5???
05-04-2010, 11:54 AM #2
- Join Date
- Nov 2006
what port ? the mag side port.
05-04-2010, 12:39 PM #3
Bottom right looking at the head from the back of the ski, theres a lil allen plug
05-17-2010, 11:54 AM #4
05-17-2010, 02:26 PM #5
05-17-2010, 02:49 PM #6
05-17-2010, 10:27 PM #7
I assume your talking about oil pressure feed??
Then yes there is a 1/8 NPT thread on the cylinder head.
Also the oil pressure sensor is 1/8 NPT as well and you can tee off that.
05-17-2010, 11:38 PM #8
05-18-2010, 07:41 AM #9
on the micro fiche it says that plug is 10MM not 1/8npt. i have tried to screw in a 1/8npt fitting and it is so tight going to strip, boat is an 04
05-18-2010, 12:48 PM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By JimC in forum 4-Tec PerformanceReplies: 1Last Post: 04-17-2008, 05:05 PM
By SideFX in forum Sea Doo Open DiscussionReplies: 2Last Post: 04-05-2008, 05:02 PM
By BR549 in forum Yamaha PWC Performance (2-stroke)Replies: 4Last Post: 02-10-2008, 10:39 AM
By porksword in forum Yamaha PWC Performance (2-stroke)Replies: 10Last Post: 07-16-2007, 09:21 PM
By thebert in forum Yamaha PWC Performance (2-stroke)Replies: 8Last Post: 01-17-2007, 08:37 AM