Results 1 to 2 of 2
  1. #1
    CajunSki's Avatar
    Join Date
    Jun 2009
    Location
    Louisiana
    Posts
    24

    Carb Rebuild 800 XLT

    Well, after speaking with Oside (Thanks again) about rebuilding carbs I decided to give it a try. So far it has not been to bad, but the broken/stripped screws are killing me. I have made it a point to replace all old hardware with new SS as I go. Hopefully this will make it easier the next time. Thanks to all the guys on this site with helpful insight. It sure does make things easier. The carbs were pretty dirty on the outside, but inside wasn't to bad. Both low speed adjusters were frozen and required the use of vise grips after I broke the t-handles off. New ones on the way. High speed screws were ok.
    Attached Thumbnails Attached Thumbnails Click image for larger version. 

Name:	IMG_1392.jpg 
Views:	98 
Size:	111.2 KB 
ID:	188481   Click image for larger version. 

Name:	IMG_1398.jpg 
Views:	83 
Size:	128.7 KB 
ID:	188482  


  2. #2
    CajunSki's Avatar
    Join Date
    Jun 2009
    Location
    Louisiana
    Posts
    24
    Some views of the carbs apart and cleaned. I tried several different paints, but, settled on the engine enamel. The hammer finish that Oside showed in one of his post was great but it peeled as soon as a solvent touched it. I would love to powder coat the pieces but time is not on my side. Too many hobbies and to much travel.
    Attached Thumbnails Attached Thumbnails Click image for larger version. 

Name:	IMG_1499.jpg 
Views:	82 
Size:	74.4 KB 
ID:	188484   Click image for larger version. 

Name:	IMG_1500.jpg 
Views:	75 
Size:	83.8 KB 
ID:	188485   Click image for larger version. 

Name:	IMG_1508.jpg 
Views:	71 
Size:	74.8 KB 
ID:	188486  

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Question on carb rebuild for xlt-1200
    By littlejohn in forum Yamaha PWC Performance (2-stroke)
    Replies: 4
    Last Post: 07-04-2014, 02:15 PM
  2. Newbie Carb rebuild "stock" XLT 1200 - 2004
    By minigranis in forum Yamaha PWC Performance (2-stroke)
    Replies: 7
    Last Post: 12-12-2012, 07:40 AM
  3. 01 XLT 1200 Carb Rebuild?
    By gsxguy in forum Yamaha PWC Performance (2-stroke)
    Replies: 2
    Last Post: 08-12-2011, 10:28 AM
  4. xlt carb rebuild
    By jeff12pv in forum Yamaha PWC Performance (2-stroke)
    Replies: 8
    Last Post: 01-30-2011, 02:26 AM
  5. Carb Removal 800 xlt won't come off
    By agentslinger in forum Yamaha PWC Performance (2-stroke)
    Replies: 3
    Last Post: 09-01-2009, 07:00 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •