Results 1 to 6 of 6
  1. #1

    normal for gp1300r to cut out for a bit @ WOT?

    i have stock premix 2004 gp1300r. it rides fine but at WOT for long time. sometime it cuts out when i hit a small wake. i have 2-3 bars of gas.


  2. #2
    Hydrotherapy's Avatar
    Join Date
    Sep 2006
    Location
    The Rock
    Posts
    3,347
    +1
    17
    not normal at all...

    check the battery connections are tight..
    if thats all good work thrlought the connections and i would be tempted to looking to the tip over sensor..but tip over sensor normaly cut engine when wave jumping,
    search for tip over sensor and you will see how we disable them with either cable ties or mastic

  3. #3
    there tight. im thinking cause i was running low on gas that it moves up and down cause fuel wasnt getting injected? it didnt turn off , just cut out for 1 sec

  4. #4
    Hydrotherapy's Avatar
    Join Date
    Sep 2006
    Location
    The Rock
    Posts
    3,347
    +1
    17
    Quote Originally Posted by djpeetur View Post
    there tight. im thinking cause i was running low on gas that it moves up and down cause fuel wasnt getting injected? it didnt turn off , just cut out for 1 sec
    could be low fuel but most of us run low fuel for speed runs and i have not read about this happening on two bars...could be your fuel gauge is way out and your way lower on fuel than you think and starving the engine like you say

  5. #5
    Mike xsockguyx's Avatar
    Join Date
    Sep 2007
    Location
    NJ
    Posts
    1,744
    +1
    2
    Does it ever cut out when you have a full tank?

  6. #6
    did compression test with snap on tool. 100-90-110 . i think my middle cylinder is going bad. cause i couldnt not rev over 4k rpm for a while, i guess it got stuck. but later on it ran, gonna get the front 2 piston redone . ski has 120 hours. rear piston been done 10 hours ago

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Buying used personal watercraft, what to look out for
    By jimmayor007 in forum Sea Doo Open Discussion
    Replies: 3
    Last Post: 11-26-2013, 08:37 PM
  2. Test Riding Used 2004 Rxp Tomorow, What To Look Out For
    By TDSTYG in forum 4-Tec Performance
    Replies: 19
    Last Post: 08-22-2007, 10:29 PM
  3. Test Riding Used 2004 Rxp Tomorow, Waht To Look Out For
    By TDSTYG in forum 4-Tec Performance
    Replies: 0
    Last Post: 08-21-2007, 09:29 PM
  4. Is it normal for the cylinders not to be the same size?
    By jpa1300 in forum Yamaha PWC Performance (2-stroke)
    Replies: 10
    Last Post: 08-21-2007, 12:21 PM
  5. What does it take for a GP1300R to beat an RXP?
    By Lurker in forum 4-Tec Performance
    Replies: 29
    Last Post: 09-16-2005, 12:49 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •