Thread: Exaust Manifold Tap
05-17-2010, 04:38 PM #1
Exaust Manifold Tap
Can someone explain to me what is involved in this process...I will be taking it to a machine shop to have it done...I just don't understand what instructions i should give to the machinist...I know the location where to have it tapped...but is that area water jacketed?...do you just drill all the way through?...
05-17-2010, 07:51 PM #2
05-17-2010, 09:33 PM #3
I dont have the actual details as I had mine done by Louis914 on here. So he may be able to help you out or contact BigDaddyRXP, he had a few done as well. Here is a pic. If it is pre 08 it is a little more trickier. Here is a pic of the 08 that I had done. I know this doesnt answer your questions exactly, but gives you a couple of contacts.
BTW - yes, you drill all the way through and have it tapped.
05-18-2010, 01:45 PM #4
OK...thanx for the reply and the contacts.....cheers..!!
05-18-2010, 01:51 PM #5
Bring the machine shop the sensor. They should know what to do from there.
05-18-2010, 01:57 PM #6
well yes i plan on doing that...just wanted to know if you drill all the way through to exaust passage..it would seem that it should be...but don't quite understand...don't want to ruin it...$$$$
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By howestek in forum Yamaha PWC Performance (2-stroke)Replies: 25Last Post: 10-02-2007, 08:49 PM
By The Bandit in forum Sea Doo Open DiscussionReplies: 2Last Post: 11-17-2006, 03:03 PM
By GeoRXT in forum 4-Tec PerformanceReplies: 11Last Post: 09-16-2006, 03:08 PM
By jeff007 in forum Yamaha PWC Performance (2-stroke)Replies: 3Last Post: 09-14-2006, 09:45 AM
By godfather in forum 4-Tec PerformanceReplies: 9Last Post: 12-15-2005, 09:31 AM