Results 1 to 4 of 4
  1. #1

    How far do you drill to get to the low speed screw?

    I've gone about 1/4" and still dont see the screw!

    They are 44 BN I's.


  2. #2
    XL1200Ltd-Keith's Avatar
    Join Date
    Aug 2005
    Location
    Arizona
    Posts
    506
    You just break the surface, it is about 1/16" thick.

    http://www.cajundude.com/jetskihome.htm

    http://www.cajundude.com/carbrejet.htm

  3. #3

  4. #4
    Thank you so much

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. how often do you need to rebuild x chargers
    By Jstcdoit in forum Sea Doo Sport Boats
    Replies: 13
    Last Post: 08-19-2013, 06:53 PM
  2. How bad do you want to go boating?
    By LaveyT in forum Polaris Open Discussion
    Replies: 11
    Last Post: 01-05-2011, 07:02 PM
  3. How to adjust the low speed screws?
    By MalinTas in forum Yamaha PWC Performance (2-stroke)
    Replies: 3
    Last Post: 07-13-2010, 09:29 PM
  4. How do I get to the center carb screw?
    By turk0004 in forum Polaris How To & FAQs
    Replies: 8
    Last Post: 09-18-2007, 10:05 PM
  5. How do you explain to your wife that...
    By Pale Rider in forum Sea Doo Open Discussion
    Replies: 20
    Last Post: 12-05-2005, 07:48 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •