Thread: crazy ideas for rxp hull
05-20-2010, 07:09 PM #1
crazy ideas for rxp hull
it may work wonderful
it may spit me off at 40
bought a blown out rxp hull ..and using the s3 as inspiration...
took lot of measurements and made templates..but the rxp is 2 foot shorter
after 2 days..lots of work to still do
then i need to make a set of these for my ski ..got the 1 7/8 bends for the ski ...when i ordered the ones for this set in a 69 baracuda 2 1/8 primarys ...++++ no room more sexy curves ..that at a stripper convension in vegas.. tight but got it..
05-20-2010, 07:22 PM #2
anybody got any anti itch cream?????
the s3 hull get alot of its lift from the center keel just infront of the intake grate.. it is also about 2 inches deeper in the water there as well ..the bottom curves infront of the intake grate..and lets the water enter the intake grate..smother..
the front is much more pointy ..as are most high speed boats... so it should go through chop and wakes much better...it should go more through the wave rather.. than bounce up and over it..
the chines are also much sharper..
then there is the step to break the surface tension and let air in
05-20-2010, 07:50 PM #3
It looks very promising in person.
This will definately make a huge change in the way that hull is going to handle, and run thru chop. Can't wait to see the updates on your progress with this.
05-20-2010, 07:53 PM #4
05-20-2010, 08:45 PM #5
I'm watching this....
05-20-2010, 08:54 PM #6
05-20-2010, 08:57 PM #7
05-21-2010, 12:02 AM #8
- Join Date
- Aug 2009
- Discovery Bay, CA
when you get a set of those 1 7/8 bends to fit with a nice water jacket set up..... let me be the first on the list for one!!
05-21-2010, 06:30 AM #9
05-21-2010, 07:10 AM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Vern in forum 4-Tec PerformanceReplies: 93Last Post: 12-20-2011, 05:17 PM
By MaxMike in forum Sea Doo Sport BoatsReplies: 4Last Post: 03-19-2008, 03:52 PM
By baba850r in forum 4-Tec PerformanceReplies: 5Last Post: 03-12-2008, 06:37 AM
By excess in forum 4-Tec PerformanceReplies: 9Last Post: 01-17-2008, 08:47 PM
By LAB69 in forum Sea Doo Open DiscussionReplies: 13Last Post: 02-04-2007, 06:45 PM