Thread: trim motor #2...dead!
09-22-2006, 04:23 PM #1
trim motor #2...dead!
I had to replace my trim motor on my sl750 about a month before I had to tear the boat apart to repair the hull. now, after over a year of sitting in a box, the boats back together, and the motor isnt working...AGAIN!
I really dont wanna buy another one, is there a simple way to repair these? the last time it was the motor itself that died. I havent looked inside this one yet to figure out the cause.
09-22-2006, 04:29 PM #2
I have heard that you can use a motor from a rc car. Or check with graniger.com.
09-22-2006, 04:37 PM #3Originally Posted by beerdart
09-22-2006, 10:08 PM #4
mine did the same thing...i took it apart, sprayed the motor down with wd-40, that broke down the rust and now it works just fine
09-23-2006, 11:16 AM #5
I'd definately put the power and ground directly to the motor and swap the wires a few times, add a little WD-40 it should free right up.
09-24-2006, 08:13 PM #6Originally Posted by ph2ocraft
I broke the steering cable out on lake erie today. I also discovered a few small seal leaks around the pump houseing. I'm done fiddling with this thing for a while. time to winterize and call it a year.
but thanx for the help guys.
09-24-2006, 10:12 PM #7
Sorry to see you put it away so early!! By the way do you want to pay shipping for a cable from Cali? If you have the NON extended pump I have a great cable, I changed mine for a longer cable when I did my extended pump.
09-25-2006, 11:01 AM #8Originally Posted by ph2ocraft
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Drkvampire2001 in forum Polaris ClassifiedsReplies: 3Last Post: 09-21-2013, 04:53 PM
By scottr2200 in forum Polaris Open DiscussionReplies: 8Last Post: 07-12-2007, 02:42 PM
By jsc7002 in forum Polaris Open DiscussionReplies: 3Last Post: 07-08-2007, 11:51 PM
By posfit in forum Polaris Open DiscussionReplies: 13Last Post: 07-06-2007, 09:59 PM
By beerdart in forum Polaris Open DiscussionReplies: 9Last Post: 04-11-2007, 02:06 PM