Thread: ET137 but no gain
05-24-2010, 01:41 PM #1
ET137 but no gain
X charger with A kit 8100 rpm and 11 psi boost
Then I replace the A kit ----> ET137 8100 and 12.8 psi ( 48 lbs injectors )
I have no gain. Where is the problem
05-24-2010, 01:52 PM #2
You are on the rev limiter
05-24-2010, 01:52 PM #3
What ECU? You might be close to the limiter ... if you are not on the limiter and have seen 1.8 psi more boost on your gauge, you absolutely should see more speed and rpm.
05-24-2010, 01:55 PM #4
Its a STOCk ecu. I have put 1 mm to my prop and run 8000 rpm. My speed is the same A kit vs ET137 ?????
05-24-2010, 02:00 PM #5
Re: ET137 but no gain
Is there really 1.8 lbs boost difference between those two wheels?? Do you notice more bottom end punch?
05-24-2010, 02:06 PM #6
Was this back to back or atleast similar weather conditions?
05-24-2010, 02:08 PM #7
05-24-2010, 02:10 PM #8
I think you were higher than 11 lbs for your A wheel.
05-24-2010, 02:12 PM #9
05-24-2010, 02:13 PM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By davesgpr in forum Yamaha PWC Performance (2-stroke)Replies: 32Last Post: 04-19-2008, 01:19 AM
By dongee in forum Yamaha PWC Performance (2-stroke)Replies: 0Last Post: 07-07-2007, 08:27 PM
By jpa1300 in forum Yamaha PWC Performance (2-stroke)Replies: 9Last Post: 03-04-2007, 02:44 AM
By Water4fire in forum Sea Doo Open DiscussionReplies: 43Last Post: 03-22-2006, 08:28 PM
By Jarrett in forum 4-Tec PerformanceReplies: 9Last Post: 07-07-2005, 07:01 PM