Thread: Pump info
05-26-2010, 12:34 PM #1
Guys, I would appreciate and detailed info including pics if possible on pump assembly (bearings, seals, etc...) and any mods to reduce bearing wear and such...
05-26-2010, 11:36 PM #2
05-27-2010, 10:01 AM #3
Most people with serious HP send the pump to Skat for their double bearing mod (or triple bearing mod). Skat installs a different tail cone that then uses oil in the pump rather than grease ... most also have them press in a SS liner rather than the plastic liner. If the motor is aligned properly and the mounts are solid, this setup tends to run a long time.
05-27-2010, 03:31 PM #4
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By mastacks in forum 4-Tec PerformanceReplies: 7Last Post: 04-24-2008, 09:38 AM
By nexxxx in forum Yamaha Open DiscussionReplies: 1Last Post: 04-01-2008, 08:30 PM
By ABBOTT in forum Yamaha How To & FAQsReplies: 11Last Post: 02-04-2008, 06:46 PM
By Justified Too in forum 4-Tec PerformanceReplies: 29Last Post: 08-10-2007, 05:58 AM
By rapidacceleration in forum 4-Tec PerformanceReplies: 4Last Post: 07-04-2006, 10:18 AM