Thread: 2004 MSX 110 Engine Job
05-28-2010, 07:50 PM #1
- Join Date
- May 2010
2004 MSX 110 Engine Job
Any comments please post it.. I have a MSX 110 that sucked H20 into the oil cooler. It threw the back rod bearing... after looking at the parts manual, I do not see oversize rod bearings, my crank needs cutting to first oversize. I would like a good parts source,(any ideas would help).
Also noticed that the timing chain does not have a master link on it.. I used to do 12 cyl. engines and they all had masterlinks, I will be putting a masterlink onto the timing chain...(any comments?)
I am also looking for a the digital wrench software with the cables.
I rebuild detroit diesel 2 cycles, and the new 4 cycle engines with the electronic DDEC's(detroit diesel electronic controll) I included this info to show that this is not my first engine...although one cyl. on a Detroit Diesel 60 series is as big as this MSX110.
My # is 863 633 8517
05-28-2010, 08:56 PM #2
- Join Date
- Jul 2007
- near Toronto, Canada
Contact Randy at Watcon.com, or Jay at Sharp's Marine.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By fusion900 in forum MSX/MatrixReplies: 9Last Post: 04-23-2008, 08:06 AM
By viperbusa in forum MSX/MatrixReplies: 4Last Post: 02-08-2008, 09:18 AM
By sergiyk in forum Polaris Open DiscussionReplies: 3Last Post: 06-05-2007, 05:11 PM
By posfit in forum Polaris Open DiscussionReplies: 3Last Post: 06-02-2007, 08:47 AM
By posfit in forum Polaris Open DiscussionReplies: 5Last Post: 05-26-2007, 06:40 AM