Results 1 to 5 of 5
  1. #1

    Join Date
    Jun 2008
    Location
    florida
    Posts
    168

    Help with taper bore carbs

    I got a set of carbs for my 96 xp it looks like someone took a dremel and kind of bored the throat of the carbs out some .I was wondering if I need to open the high or low speed screws some because of this ? they have the stock jets in them .


  2. #2
    96XPSS's Avatar
    Join Date
    Feb 2006
    Location
    Warner Robins, GA Home of the 2007 All-Star Little League World Champions!
    Posts
    4,361
    Sounds kinda scary. Can you post up pics? Depending on how much larger the bore is, you may need bigger pilots.

  3. #3

    Join Date
    Jun 2008
    Location
    florida
    Posts
    168
    Ok so I installed the taper bored carbs and it started fine but it started to run away which I think means a lean condition . right ? pics arnt to good but the best i could get .
    Attached Thumbnails Attached Thumbnails Click image for larger version. 

Name:	DSC01487.jpg 
Views:	44 
Size:	50.6 KB 
ID:	190909   Click image for larger version. 

Name:	DSC01489.jpg 
Views:	38 
Size:	65.2 KB 
ID:	190910  

  4. #4
    96XPSS's Avatar
    Join Date
    Feb 2006
    Location
    Warner Robins, GA Home of the 2007 All-Star Little League World Champions!
    Posts
    4,361
    Yes lean. To confirm pump your primer, it should settle down immediately.

    Bump the pilots up to 80, are you running flame arrestors?

  5. #5

    Join Date
    Jun 2008
    Location
    florida
    Posts
    168
    when I pull the choke it settles down .and yes in running flame arrestors . what do you thinkis a good starting point with my high and low mixture screws ?
    thanks again

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Polaris 1200 X 45 with Mikuni 44 taper bored Carbs Need Carb settings
    By Vagaondracing103 in forum Polaris PWC Performance
    Replies: 0
    Last Post: 03-08-2013, 12:00 PM
  2. Help with keihin triple carbs
    By jasthecase in forum Polaris How To & FAQs
    Replies: 6
    Last Post: 07-06-2012, 06:18 PM
  3. Help with Novi 42I carb jetting.
    By Piranha Performance in forum 2-Stroke Performance
    Replies: 34
    Last Post: 04-23-2010, 07:38 AM
  4. Help with cyl. bore questions
    By 9t8gp1200 in forum Yamaha Old School Skis
    Replies: 8
    Last Post: 06-02-2009, 09:29 AM
  5. Help with a gp760 carb
    By Blackhardt in forum Yamaha Old School Skis
    Replies: 1
    Last Post: 07-04-2007, 09:29 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •