06-03-2010, 07:31 PM #1
Just removed pump and found a black o ring. Where does it go?
I removed my pump today after a sucked seaweed into the intake grid and after reading a couple of threads I tried to remove the pump which really wasn't that difficult.
My question is though that when I removed the pump, I found a small black "O" ring and wanted to make sure it made it back to the proper location before putting everything back together.
Also, I have 70hours on the ski and see some nics on the prop and the wear ring looks decent. Should I just go ahead and file the nics on the prop and see how things run once it's back together? Or should I reverse the wear ring while it's out?
Oh and by the way, this is my first ski and I have to tell you that this site is a real life saver. The information I've learned on my ski so far came from only Greenhulk!
06-03-2010, 07:45 PM #2
There are two o-rings used for the bailer ports on the top of the exit nozzle... check there.
06-03-2010, 07:58 PM #3
I'm sorry but when you are referring to the bailer ports, are those the two at the top center area on the ski and not the pump assy? Is this something you can point out to me in my picture that was posted?
06-03-2010, 08:03 PM #4
The two o-rings go on the exit nozzle... and seal up to this surface.
06-03-2010, 08:16 PM #5
Thanks for the pic. After looking around my work area, I only have the one "O" ring. Is this something I'd have to go to Seadoo to purchase or would a local hardware shop have something like this?
06-03-2010, 08:18 PM #6
Check the exit nozzle for the other one... sometimes they don't fall off of it when removed.
06-03-2010, 08:34 PM #7
I have a couple of pics...I think they are already on the venturi? It looks like this "O" ring is larger than the opening on the exit pump.
06-03-2010, 08:40 PM #8
As see in this break down... there are no other o-rings other than the two between the pump & exit nozzle... that would have fallen out by just pulling the pump from the ski.
06-03-2010, 08:46 PM #9
Thanks for all your help! If I can't find the other one, I'll just try my local Seadoo shop for the parts.
06-04-2010, 08:51 AM #10
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Mr1300 in forum Yamaha PWC Performance (2-stroke)Replies: 15Last Post: 12-17-2007, 10:39 PM
By Dr Len in forum Sea Doo Open DiscussionReplies: 17Last Post: 07-22-2007, 10:08 PM
By 1FastRXP in forum Kawasaki PWC Performance (4-stroke)Replies: 6Last Post: 04-29-2007, 08:45 AM
By falcon in forum Polaris How To & FAQsReplies: 1Last Post: 03-30-2007, 05:53 PM
By WATER WOODY in forum Yamaha PWC Performance (2-stroke)Replies: 39Last Post: 06-12-2006, 08:06 PM