Thread: Engine Building Specs for 4tec
06-08-2010, 09:27 PM #1
- Join Date
- Jun 2008
Engine Building Specs for 4tec
Im sure im probably missing something in the sea doo service manual i downloaded from here, but im looking for the bearing clearances, piston ring clearances, etc to be able to rebuild my motor.
WHere is this information in the manual if im dumb, or where might i be able to find the particulars im looking for?
06-08-2010, 11:00 PM #2
At the end of the chapter, or in SPECS section at the end of the manual. Sometimes the integrate them into the part currently being discussed.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By dav_dman in forum Sea Doo Open DiscussionReplies: 43Last Post: 01-28-2009, 02:48 AM
By boostaholic in forum Conversion Skis ClassifiedsReplies: 1Last Post: 11-25-2007, 04:44 PM
By MikeTrin in forum Sea Doo Open DiscussionReplies: 30Last Post: 11-13-2007, 03:36 AM
By tibrin04 in forum 4-Tec PerformanceReplies: 6Last Post: 10-31-2007, 05:19 PM
By AintStuck4x4 in forum 4-Tec PerformanceReplies: 3Last Post: 06-19-2007, 11:28 PM