Got my 750 zxi only to find it was overheating on one cyl. Stripped top and found the cyl skirt had been previously snapped and piston had scored badly.
Got block from ebay 1mm oversize so need oversize pistons.
Before spending agin stripped lower end to find crank centre bearings were shot.
I dont have the money to get rebuild or buy new.
Can i do it my self? or do i need specialised equip.
Where would i source bearing as i have only seen them in full crank kit.
Have been told that crank may be ok for some time as outer shaft bearings are this possible.
DOES anyone have a good crank selling cheap!!?(in the uk)

or should i just sell as parts?