06-15-2010, 08:43 PM #1
anyone have problems installing new small end rod bearings??
I picked up 3 new OEM small end rod bushings, and they won't fit over the new Riva wrist pins, and there isn't any holes in them where my 04 rods, and bearings have oil holes in them.
Are these a new updated parts?, and are they supposed to be opened up , and drilled after install?
This is on my 04'RXP motor.
Also the parts list shows 2 different rod #'s between 04, and 08' for some reason, and only one bushing part #.
Any help or input would be appreciated. Thanks, Jason
06-15-2010, 09:17 PM #2
06-15-2010, 11:08 PM #3
06-16-2010, 08:32 AM #4
06-16-2010, 04:39 PM #5
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By mrjetskey in forum 2-Stroke PerformanceReplies: 2Last Post: 01-05-2008, 01:42 PM
By ercBOOSTED in forum Kawasaki PWC Performance (4-stroke)Replies: 6Last Post: 09-07-2007, 04:15 PM
By quadzilla in forum Open DiscussionReplies: 0Last Post: 07-27-2007, 01:21 PM
By sic fish in forum Yamaha PWC Performance (2-stroke)Replies: 1Last Post: 12-21-2006, 07:56 PM
By RX951 in forum Yamaha Open DiscussionReplies: 13Last Post: 05-12-2006, 11:31 AM