Thread: timing adjustments '97 sltx 1050
06-16-2010, 02:02 AM #1
- Join Date
- Aug 2009
timing adjustments '97 sltx 1050
i am replacing a sheared woodruff key and now ready to reassemble the flywheel. my concern is the timing settings. i unknowingly loosened these two allen screws and this rotates the magnets on the inside of the flywheel a few degrees. i dont remember what position they were when i loosened them. how can i set these?
06-16-2010, 08:01 AM #2
You will need to put it back as close as you can, then run the engine with a timing light to verify. If its off, you will need to pull the cover back off, adjust it, and repeat. Timing specs are here on the site under "domestic" info.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By gianni57 in forum Polaris How To & FAQsReplies: 6Last Post: 07-16-2008, 09:38 PM
By 1996SLTX in forum Polaris Open DiscussionReplies: 9Last Post: 10-24-2007, 09:28 AM
By dhd in forum Polaris Open DiscussionReplies: 0Last Post: 05-16-2007, 09:23 AM
By Polaris_Nut#1 in forum Polaris PWC PerformanceReplies: 14Last Post: 04-26-2007, 09:30 PM
By 1bad69chevelle in forum Polaris PWC PerformanceReplies: 5Last Post: 04-01-2007, 07:57 AM