Page 1 of 2 1 2 LastLast
Results 1 to 10 of 19
  1. #1
    90's Seadoo GURU Minnetonka4me's Avatar
    Join Date
    Jun 2010
    Location
    Minnetonka, MN
    Posts
    80

    1995 Seadoo SPI 580 part out!!

    ALL PRICES INCLUDE SHIPPING to 48 STATES!!! I take Paypal!

    PLEASE NOTE: I am new to GH, but I am the same name over at PWCtoday.com and the X. I guarentee all my parts. if you find something wrong with anything let me know ASAP. Send the part back and if I agree I will refund INCLUDING shipping both ways. If you order a part that doesnt fit, or you just dont need it I will refund MINUS shipping. There have been too many rip offs lately!! oh and if you want to check out my ebay feedback my ID is bonnessei 540 feedback 100%!


    PIX of everything are at the link below. Click on gallery view in upper right hand corner. http://www.mediafire.com/?sharekey=9...866ca04fb3b111


    This is a 1995 SPI I Parted down. The motor was super tired, so I parted it down. Anything not listed was either sold, or was garbage.

    Engine: (I have 3 white 580 motors I am parting down)
    Heads $70
    Cases $60
    Cylinders $60ea ready to go (2) need bore/hone $40ea (4)
    Motor cradles $40
    Set of 4 motor mounts $30
    Head temp sensor; $20
    Exhaust manifold $35
    Intake manifold; no deep scratches w/oil pump $35
    Flywheel $50
    Stator $60
    front/back flywheel housing $25
    Exhaust (2pc performance) $60
    Waterbox $40
    Tube that runs from waterbox to outlet $30

    Fuel/carbs:
    Carbs; I have no dual setups, just single 38SBNs. $40
    Throttle cable (single carb) $20
    Fuel tube to gas tank ; $15
    Choke (single carb)$15
    Water/fuel separator $15
    Air intake cover; complete w/ bolts $25
    Selector, no dial $15

    Electrical:
    Ebox holder plate $13
    fuel gauge little faded $25
    battery holder $20
    Beeper $13
    start stop housing $15
    Start stop switch $25

    Pump, body, steering, MISC.
    Driveshaft; Splines in great shape. 17” $50
    Driveshaft boot w/ bearing carrier $25
    Nozzle setup no trim $25
    Steering cable (No trim) $30
    SINGLE GAUGE Hood; little faded , but I tried the heat gun trick and it will restore $60
    Seat: lighter purple than stock, but in perfect shape $100 shipped.
    Storage bin; Will fit all X-4s $35
    Purple Front bumper; complete with plugs. $25
    Purple Corner trim pieces $20
    Purple trim, sides and back piece $40 (long)
    Stock Intake grate $20
    Bailer/siphon tubes $13
    purple bar cover very lightly faded, but little to no mildew $35
    Thumb flipper $15
    Steering assembly including handlebars $50 (heavy)
    under seat air tube $25
    Mirror complete $25
    Stock black handle bar grips $13
    Oil cap $13
    Driveshaft cover $20


  2. #2
    Work Harder, Millions on Wellfare Depend On Us! ultramaxracing05's Avatar
    Join Date
    Aug 2009
    Location
    Beaumont, Texas
    Posts
    2,999
    +1
    123
    do you know if the stator will fit a 720?

  3. #3
    90's Seadoo GURU Minnetonka4me's Avatar
    Join Date
    Jun 2010
    Location
    Minnetonka, MN
    Posts
    80
    they do, but you gotta splice the wires.
    Last edited by Minnetonka4me; 06-21-2010 at 01:32 AM.

  4. #4
    90's Seadoo GURU Minnetonka4me's Avatar
    Join Date
    Jun 2010
    Location
    Minnetonka, MN
    Posts
    80
    PM sent

  5. #5
    90's Seadoo GURU Minnetonka4me's Avatar
    Join Date
    Jun 2010
    Location
    Minnetonka, MN
    Posts
    80
    bump

  6. #6
    Work Harder, Millions on Wellfare Depend On Us! ultramaxracing05's Avatar
    Join Date
    Aug 2009
    Location
    Beaumont, Texas
    Posts
    2,999
    +1
    123
    Got the parts arrived in great condition thanks!

  7. #7
    90's Seadoo GURU Minnetonka4me's Avatar
    Join Date
    Jun 2010
    Location
    Minnetonka, MN
    Posts
    80
    No problem man its always that quick and packed that good!

  8. #8
    Work Harder, Millions on Wellfare Depend On Us! ultramaxracing05's Avatar
    Join Date
    Aug 2009
    Location
    Beaumont, Texas
    Posts
    2,999
    +1
    123
    Bump for a good guy, great prices and fast shipping.

  9. #9
    90's Seadoo GURU Minnetonka4me's Avatar
    Join Date
    Jun 2010
    Location
    Minnetonka, MN
    Posts
    80
    TTT

  10. #10

    Do you still have the mirror?

    Is the mirror stll available, if so, do you have pictures?
    Milo


    Pump, body, steering, MISC.
    Driveshaft; Splines in great shape. 17” $50
    Driveshaft boot w/ bearing carrier $25
    Nozzle setup no trim $25
    Steering cable (No trim) $30
    SINGLE GAUGE Hood; little faded , but I tried the heat gun trick and it will restore $60
    Seat: lighter purple than stock, but in perfect shape $100 shipped.
    Storage bin; Will fit all X-4s $35
    Purple Front bumper; complete with plugs. $25
    Purple Corner trim pieces $20
    Purple trim, sides and back piece $40 (long)
    Stock Intake grate $20
    Bailer/siphon tubes $13
    purple bar cover very lightly faded, but little to no mildew $35
    Thumb flipper $15
    Steering assembly including handlebars $50 (heavy)
    under seat air tube $25
    Mirror complete $25
    Stock black handle bar grips $13
    Oil cap $13
    Driveshaft cover $20[/QUOTE]

Page 1 of 2 1 2 LastLast

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. FS 1996 seadoo gsx part out, running ski
    By ultramaxracing05 in forum Sea Doo 2 Stroke Skis
    Replies: 1
    Last Post: 10-08-2009, 11:26 AM
  2. 2003 Seadoo XPDI Parting Out Monday
    By 2blue in forum 2-Stroke Performance
    Replies: 1
    Last Post: 08-30-2009, 07:01 PM
  3. Sea Doo SPI parting out
    By torquenut3 in forum Sea Doo Classifieds
    Replies: 1
    Last Post: 07-01-2008, 08:46 PM
  4. Seadoo Spi bogging out, no fuel
    By PhilnEdee in forum 2-Stroke Performance
    Replies: 5
    Last Post: 09-06-2007, 08:52 AM
  5. 1997 seadoo xp cutting out
    By Stoffa17 in forum 2-Stroke Performance
    Replies: 2
    Last Post: 07-06-2007, 09:37 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •