Results 1 to 3 of 3
  1. #1

    Ok Groco installed

    On my 2006 RXP. I installed in front of the engine. I had to add about 9" of hose. After tightning evrything I started her up then added the water. the strainer actually had some crap from the hose. Came out good and wasnt as hard as I thought. Of course I dropped a wrench inside the hull and was a pain to get to. Everything always goes the very bottom under something.

  2. #2
    I pew pew lazors
    Join Date
    Mar 2010
    Under the engine isn't bad when you consider I dropped a mini maglite down the hull on the right side of the gas tank. Now that was a pain in the ass!

  3. #3
    Well 2 small screws are still there. I gave up. I used an air compressor to get them out but hothing.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Groco ic strainer?
    By N8T in forum 4-Tec Performance
    Replies: 7
    Last Post: 03-04-2008, 10:21 AM
  2. Groco strainers
    By ERICG1 in forum 4-Tec Performance
    Replies: 21
    Last Post: 10-31-2007, 11:36 AM
  3. Groco Strainer
    By Antiguan FZR in forum Kawasaki PWC Performance (4-stroke)
    Replies: 1
    Last Post: 06-22-2007, 02:47 PM
  4. Groco Strainer
    By Flynfox in forum Sea Doo Open Discussion
    Replies: 2
    Last Post: 06-03-2007, 12:19 PM
  5. Finally installed my groco filter on my RXT
    By beached log in forum 4-Tec Performance
    Replies: 1
    Last Post: 12-05-2006, 08:09 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts