06-17-2010, 01:13 AM #1
My Experience with New Ferrea Light weight Valves (Gen II)
I used in previous the Ferrea Light weight valves … Old Gen thay are ok ... but I decide to go with the new Gen II … After I install them I had sound like the valve hitting the Piston … I took off the cylinder engine off and check and there is to signe of valves hitting the piston and I install the head aging and install new rocker arm .. Same problem … I decide to go back to the OEM valves the one I hade before and every thing goes back to normal and no sound at all …
Any one out there had same experience with the ferrea Gen II valves?
06-17-2010, 02:43 AM #2
06-17-2010, 03:52 AM #3
06-17-2010, 04:15 AM #4
With oversize, you have to mill out a detent in the piston crown.
It's not just as easy as head work only.
The noise you may hear is the slapping of the lifters against the cam if the engine is not running, and no oil pressure.
Of course, make sure you have it all timed correctly.
06-17-2010, 08:20 AM #5
06-18-2010, 10:44 PM #6
what happend is it fixed? what was done incorrect??
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Green Hulk in forum 4-Tec PerformanceReplies: 6Last Post: 04-17-2008, 03:25 PM
By BahamasGPR in forum Yamaha PWC Performance (2-stroke)Replies: 1Last Post: 04-08-2008, 11:44 PM
By vidbuster in forum 4-Tec PerformanceReplies: 9Last Post: 04-03-2008, 08:47 AM
By Krazy-K in forum 4-Tec PerformanceReplies: 5Last Post: 07-14-2005, 09:49 PM
By tchies in forum Sea Doo Open DiscussionReplies: 0Last Post: 06-27-2005, 07:05 PM