Results 1 to 3 of 3
  1. #1

    how to remove waterbox

    hey guys im about to do the waterbox mod but im not sure how to remove the exhaust. im guessing it is the clamp which you loosen the the nut up the thread which will separate the clamp. is this right? if so what do you guys use to undo the nut just a deep socket?
    thanks troy


  2. #2
    oh its on a 07 rxp too

  3. #3
    Richieb's Avatar
    Join Date
    Oct 2008
    Location
    Sydney, Australia.
    Posts
    1,001
    10mm deep socket.
    Hoses top and bottom of the manifold end where the clamp is... and dont forget to replace them..!!

    Hose off the top of the J-Pipe, bottom clamp off the J-Pipe end, Hose off the box to resonator pipe.

    Un-clip the exhaust temp sensor from the box, and keep it dry.

    Big flat blade driver with a notch cut in the end of it. Put the notch into the metal end of the strap that holds the box in, and push it downward, it will unclip.

    Et voila!!

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. does anyone know how to remove the exhaust tip that goes into the waterbox?
    By bscpaint in forum Yamaha PWC Performance (4-stroke)
    Replies: 13
    Last Post: 03-27-2016, 12:33 AM
  2. How to remove a driveshaft?
    By 01xdime in forum 4-Tec Performance
    Replies: 10
    Last Post: 08-30-2009, 07:44 PM
  3. How to Remove the Throttle Body
    By johnD in forum 4-Tec Performance
    Replies: 11
    Last Post: 04-21-2007, 11:39 AM
  4. Bad Mats --> peeled em off, how to remove glue?
    By Shibby1485 in forum 4-Tec Performance
    Replies: 12
    Last Post: 11-26-2005, 12:35 AM
  5. How-To: Removing the engine cowling.
    By MikeTrin in forum Sea Doo How To & FAQs
    Replies: 8
    Last Post: 06-23-2005, 10:28 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •