Results 1 to 5 of 5

Thread: Oil inj. Pump

  1. #1

    Join Date
    Jun 2010
    Location
    sutter, ca.
    Posts
    16

    Oil inj. Pump

    I HOOKED MY OIL INJ. PUMP BACK UP, IT WILL NOT PUMP OIL WHILE CRANKING OVER ENG. DO I HAVE TO PRIME OR BLEED IT? 0R DOES IT RUN OFF VACUME FROM INTAKE? ITS A 94 SL750.


  2. #2
    Clayton G's Avatar
    Join Date
    Apr 2009
    Location
    Upper Peninsula of Michigan
    Posts
    143
    You need to bleed it. The bleed screw is the shiny 8mm bolt on the end of the pump. Open it until you get a good flow of oil, no air bubbles. You should also fill the small lines from the pump to each cylinder. Mityvac works good, a syringe does also. If you don't have either, the suck on it like a straw works. Good Luck

  3. #3

    Join Date
    Jun 2010
    Location
    sutter, ca.
    Posts
    16
    Thank you ill do that...

  4. #4

    Join Date
    Apr 2010
    Location
    Michigan
    Posts
    64
    is there a picture or diagram for the bleeding? I'm in the same boat, had to replace the oil line to the pump and I now have a bubble at the top of the tube where it connects to the pump.

    Thanks for the help...

  5. #5
    Clayton G's Avatar
    Join Date
    Apr 2009
    Location
    Upper Peninsula of Michigan
    Posts
    143
    I don't know of a picture or diagram here on GH, might be one. Maybe try the search, But it"s quite easy. Just loosen the blead screw and watch the bubble, may have to coax it out by pinching it. Just make sure you don't damage the oil line. And you're welcome.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Oil inj.pump
    By 3-banger in forum Polaris Open Discussion
    Replies: 1
    Last Post: 07-01-2010, 10:31 PM
  2. oil suction pump?
    By Brewer3 in forum Kawasaki PWC Performance (4-stroke)
    Replies: 5
    Last Post: 06-02-2007, 04:07 PM
  3. Oil injection pump
    By Blackhardt in forum 2-Stroke Performance
    Replies: 4
    Last Post: 11-03-2006, 09:11 AM
  4. Oil in pump bearings?
    By r33pwrd in forum Yamaha PWC Performance (2-stroke)
    Replies: 31
    Last Post: 05-23-2006, 01:25 PM
  5. Oil changer pumps
    By way2fast in forum Sea Doo Open Discussion
    Replies: 1
    Last Post: 08-26-2005, 01:33 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •