07-01-2010, 06:00 PM #1
- Join Date
- Jul 2010
Polaris 700SLT Break-in Procedure!
Hey guys I am new to this forum so bear with me.
I got this 97 Polaris SLT700. PTO piston was bad so removed it sent it to get bored to 1.5mm oversize and bought oversize SBT pistons. Now I am almost done with the job. My question is what is the break in procedure and how long is the break in procedure? I heard somewhere I should premix 50;1 in the gas tank together with oil pump running to make sure while engine breaking in it will have plenty of lubrication. How much should I run at first start? how much throttle play? like should I give it any throttle or just let it idle? its my first time breaking in to anything other than my rc planes. ANy suggestions will be appreciated.
07-01-2010, 09:50 PM #2
- Join Date
- Jul 2007
- near Toronto, Canada
Engine break-in has been covered in a number of previous threads. Searching should find it, but the forum software on here was recently upgraded, so not everything is back to working as it should.
I just bought a Polaris PWC - what should I do?
Click here for guidance to help you get your Polaris PWC running properly, and keep it on the water.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By jscottmsc in forum Kawasaki PWC Performance (4-stroke)Replies: 50Last Post: 09-12-2008, 05:27 PM
By watler82 in forum Kawasaki PWC Performance (4-stroke)Replies: 6Last Post: 03-10-2008, 02:41 AM
By BigDaddyPT in forum Polaris PWC PerformanceReplies: 16Last Post: 06-26-2007, 07:58 PM
By ashstott40 in forum Yamaha PWC Performance (4-stroke)Replies: 14Last Post: 06-14-2006, 06:25 AM
By SUPERBEAST in forum Sea Doo Open DiscussionReplies: 1Last Post: 05-09-2005, 05:53 AM