07-02-2010, 11:37 PM #1
Performance worst after running over debris/sand.
I found that my PWC performance worst after running over debris/sand.
I have check impeller ,and seem it's ok,
water cooling seem ok also,becuase of water come out as normal.
Could anyone help me figure out,what 's might a reason for performance drop
My PWC 2010 run only 13Hr+ ,
as before i have 110Kmh at WOT,but now unable to reach it at WOT ,ony 105Kmh.
Anything i need to check/clean sand might be there in my engine/intercooler?
Please suggest me how to check/clean or give me some advice.
07-03-2010, 08:54 AM #2
jack if you have run something over the chances ar you will ned to rfurb your impellor
07-03-2010, 12:53 PM #3
07-03-2010, 03:41 PM #4
07-04-2010, 08:12 AM #5
thank for all reply
I have ordered Intercooler Water Filter Kit ,
and will install it in a few days.
I did have back flush a intercooler(put water reverse back through water outlet)
But i think i found more problem,look like impeller do not well balance also.
Becuase of my PWC have much totter when running than before.
So far so good,i will try to install some strainer for sure.
07-05-2010, 08:38 PM #6
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By ph2ocraft in forum Sea Doo Sport BoatsReplies: 12Last Post: 09-19-2010, 10:57 AM
By rx4pain in forum Sea Doo Open DiscussionReplies: 21Last Post: 01-11-2008, 01:02 AM
By charger in forum Honda Open DiscussionReplies: 3Last Post: 12-24-2007, 07:10 PM
By BR549 in forum Yamaha PWC Performance (2-stroke)Replies: 5Last Post: 05-14-2007, 11:22 PM
By WildBill9000 in forum 4-Tec PerformanceReplies: 4Last Post: 11-25-2005, 10:30 PM