Thread: 06 gtx standard wear ring?
07-05-2010, 09:33 PM #1
06 gtx standard wear ring?
hey guys. its me again. lol. have an 06 gtx 4tec standard that wont come outta the hole and tops out at 35mph. rpm's bounce off rev limiter. read some post's and seen where the wear ring/impeller is most likely cause.
removed pump and whoa. wear ring almost cut in half from something. when i took out impellar the ring fell out.
1st question. it did spin in the housing and broke/sheared the screws. can i still put new one in and glue/screw in? (man going on trip and wants ski badly at whatever cost for next 5 weeks)
2nd question. when i put new ring and impellar i gather from reading that they will be reall tight. do i just start and let seat/wear itself?
any help appreciated
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By MPower in forum Sea Doo Open DiscussionReplies: 2Last Post: 07-31-2007, 09:27 PM
By Zilla57 in forum Sea Doo Open DiscussionReplies: 8Last Post: 07-10-2006, 12:11 PM
By Totallyblown in forum 4-Tec PerformanceReplies: 27Last Post: 04-08-2006, 02:44 PM
By swamp rat760 in forum Yamaha PWC Performance (2-stroke)Replies: 2Last Post: 12-29-2005, 02:12 PM
By 01xdime in forum 4-Tec PerformanceReplies: 13Last Post: 08-18-2005, 04:16 PM