Thread: Need help trouble shooting
07-11-2010, 03:12 PM #1
- Join Date
- Jun 2010
Need help trouble shooting
I have a 98 Polaris 1050 that i can not get to turn over. Ran fine until yesterday and it took on water due to a water leak so we took it out of the water and today i took apart and tightened all bolts and hoses, new spark plugs in it and now it just clicks when trying to start. I then put a starter relay on it and it did the same thing. i then changed the starter its self, no change. then changed the electronic box module and still doing the same thing. any suggestions???? PLEASE..
07-11-2010, 04:53 PM #2
- Join Date
- Jul 2007
- near Toronto, Canada
Remove and clean both ends of both battery cables. Make very sure the engine end of the negative cable has lean metal-to-metal contact with the engine block.
Make sure the thin red wire from the electrical box is on the same stud as the heavy red wire from the battery.
If still no crank, start tracing the power flow from the battery into the electrical box. Make sure the Reset button has not tripped.
Make sure the Black wires in the electrical box are really grounded to the battery negative.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By Vern in forum Sea Doo How To & FAQsReplies: 27Last Post: 03-28-2012, 06:43 AM
By Larsonator in forum Polaris Open DiscussionReplies: 7Last Post: 08-22-2007, 12:42 PM
By 97GPSLEEPER in forum Yamaha Old School SkisReplies: 10Last Post: 04-16-2007, 07:23 AM
By LAB69 in forum 4-Tec PerformanceReplies: 2Last Post: 02-01-2007, 05:05 PM
By patmcf79 in forum Yamaha Open DiscussionReplies: 0Last Post: 01-08-2006, 12:40 PM