Thread: Venturi Nozzles ??
10-08-2006, 09:08 PM #1
Venturi Nozzles ??
Has anyone used the Venturi Nozzles with the changeable ring sizes? I have been looking at this and it looks like an easy way to adjust how you want your pwc to move through the water.
10-08-2006, 09:30 PM #2
- Join Date
- Aug 2006
10-09-2006, 02:08 PM #3
10-09-2006, 03:59 PM #4
Depending on your intentions, I'd say bore the one you have and run an AAT.
10-09-2006, 06:05 PM #5
I have a Skat nozzle with rings from 82mm to 87mm. I use an 87mm.
10-10-2006, 09:18 PM #6
Hey SeaLion, what kind of performance increase to you get with an 87? If I remember correctly the stock size is 84. With an 87 do you have a stronger bottom end?
10-10-2006, 09:24 PM #7
Hey addicted, I was looking at the AAT but can't find where to get it. I tried e-mailing someone at wet wolf but I haven't heard back from anyone yet. Any ideas as to where I can get one?
10-10-2006, 09:36 PM #8
Give Bruce a day or two, he probably just got back from Havasu. I think he has some used units as well as new??
10-10-2006, 09:44 PM #9
10-10-2006, 09:47 PM #10
Bruce is back. He as posting this afternoon. Call him tomorrow.
I run a bored stock nozzle 87mm and an aat. The holeshot is actually too much. It just leaps out of the water, but the top end is the same as with the stock nozzle and no aat. Using a stock nozzle and the aat was a great comprimise, with good low end, and slightly better top end, but i chose to keep the bored nozzle in there for jumping.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By ActionR32 in forum 4-Tec PerformanceReplies: 9Last Post: 06-25-2008, 05:40 PM
By EGGonz in forum Kawasaki PWC Performance (4-stroke)Replies: 14Last Post: 06-19-2008, 03:33 PM
By cckeong in forum Sea Doo Open DiscussionReplies: 1Last Post: 06-12-2008, 08:06 PM
By HYNES in forum Kawasaki PWC Performance (4-stroke)Replies: 2Last Post: 05-09-2008, 05:13 PM
By rx4pain in forum 4-Tec PerformanceReplies: 20Last Post: 09-27-2007, 06:20 PM