Results 1 to 2 of 2
  1. #1

    Unhappy Loose engine mount

    Hey guys, I've got a 2001 Genesis I. Lately I noticed a lot of engine vibration and today I found the problem. The bolts that hold the rear engine mount to the engine are loose. I can just barely feel them and can't get a wrench on them. They also have locking tabs bent up around them (didn't do much good!). I'm afraid I'll have to pull the engine out just to tighten them. Any other suggestions? Thanks!

  2. #2
    Click avatar for tech links/info K447's Avatar
    Join Date
    Jul 2007
    near Toronto, Canada
    Unless you can figure out a way to tighten those bolts in the hull, the engine will have to come out.

    Be sure to make note of any thin shims under each engine mount.

    While you have the jet pump off, check the drive splines and engine coupler for wear.

    Consider replacing the seals in the through-hull bearing carrier, and check for internal bushing wear.

    Check the jet pump bearings for smooth operation.

    Fuel injected engine - correct?

    Make sure you click the link below for the Ficht engines.

    Make sure the fuel line sleeving is in place and the fuel lines are not damaged near the injector brackets.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. Loose rubber mount under front of engine
    By MWHC in forum Yamaha PWC Performance (4-stroke)
    Replies: 2
    Last Post: 08-02-2016, 05:53 PM
  2. Rxp engine mount loose
    By laplchri in forum 4-Tec Performance
    Replies: 4
    Last Post: 01-18-2016, 09:30 PM
  3. Loose engine mount
    By dgramenz in forum Polaris Open Discussion
    Replies: 2
    Last Post: 07-19-2010, 11:52 AM
  4. RR Front Engine mount
    By terryt in forum 4-Tec Performance
    Replies: 3
    Last Post: 02-28-2006, 10:28 AM
  5. RR Engine Mount
    By Kinchyle in forum 4-Tec Performance
    Replies: 6
    Last Post: 02-18-2006, 04:26 PM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts