07-21-2010, 02:09 PM #1
could this have been loosing me much power?
hi.... today i just decided to remover my lc1 sensor as i know my arf's are ok
when removing the sensor i noticed it was a few turns undone in the bung so exhaust gasses in the exhaust at pressure would of been leaking in to engine....would this have been loosing me much speed and power?
07-21-2010, 02:57 PM #2
it could be sucking the hot air plug it and gave it a run <<<
do you mind if you send the directions to install the LC1 , i have one and didnt know which wire goes to where
07-21-2010, 03:01 PM #3
07-21-2010, 04:14 PM #4
07-21-2010, 04:16 PM #5
could the burnt gasses not pollute the engine bay then be sucked in?
07-22-2010, 11:20 AM #6
- Join Date
- Mar 2010
- the moon
if it was sucking it back in that would just give it the same effect as having an egr valve system like volvo penta and others use. just re burns a small amount of exhaust gas to clean the emissions. it should not effect your performance. give us a call if you still have problems mate....
07-22-2010, 01:35 PM #7
cheers ...i have put the bung in now so it wont leak.....was hopeing for a few more rpm's lol
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By natris 785p in forum Sea Doo Open DiscussionReplies: 4Last Post: 07-16-2007, 12:12 PM
By gtx ltd in forum 4-Tec PerformanceReplies: 10Last Post: 11-23-2006, 08:48 PM
By johnD in forum 4-Tec PerformanceReplies: 19Last Post: 05-29-2006, 03:01 PM
By philip_gp1200r in forum Yamaha PWC Performance (2-stroke)Replies: 7Last Post: 05-04-2006, 09:21 AM
By mrracing in forum 4-Tec PerformanceReplies: 4Last Post: 09-17-2005, 12:26 AM