Thread: Adapter for the o2 sensor....
07-21-2010, 08:46 PM #1
Adapter for the o2 sensor....
Is someone making the adapter to screw the o2 sensor into the exhaust? What size is the sensor and what size is the plug you pull out of the pipe.?
07-21-2010, 08:53 PM #2
I have the R&D adaptor. I think Riva makes one too but not 100 percent sure. Not sure on size. It does its job and is easy to install. Once the o2 sensor goes bad, getting the RD adaptor off can be a bit of a pain but not too hard.
07-21-2010, 08:59 PM #3
i bought the riva one from jerrys store and it would not work with my lc1 kit, i ended up gitting the r&d adaptor to make it work. hope that helps
07-21-2010, 10:27 PM #4
07-21-2010, 10:39 PM #5
07-21-2010, 10:46 PM #6
07-21-2010, 11:30 PM #7
I also have install Riva one ,
because it too short,it already damage my Lc1 sensor (too much heat/water cool splash ?).
I try install bung that come with Inovative ,will report on next install(wait for 02 sensor comming).
07-22-2010, 05:47 AM #8
07-22-2010, 08:56 AM #9
07-22-2010, 09:00 AM #10
- Join Date
- Sep 2007
- Gainesville, VA
I bought the Riva one as I thought I read on here in earlier posts that the R&D was impossible to get a wrench on to tighten, where the Riva one was easier to put a wrench on. I guess i'm totally lost now, as here it says the R&D is the better adapter.
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By JFizzleJR in forum Sea Doo ClassifiedsReplies: 2Last Post: 06-02-2008, 11:38 PM
By jasonze in forum 4-Tec PerformanceReplies: 5Last Post: 01-05-2008, 08:51 PM
By JFizzleJR in forum 4-Tec PerformanceReplies: 0Last Post: 07-02-2007, 11:08 AM
By camar0 in forum 4-Tec PerformanceReplies: 9Last Post: 05-10-2007, 04:19 PM
By Kinchyle in forum Sea Doo Open DiscussionReplies: 1Last Post: 07-25-2006, 01:51 PM