07-28-2010, 01:28 PM #1
Any pics on how to use the SC tools ?
Does anybody have pics on how to use the SC tools, like where does the 4 pin wrench go to hold ? Tools In action...
07-28-2010, 08:44 PM #2
- Join Date
- Dec 2007
- Christchurch NewZealand
What tools do you have there are a few one plate to bolt the housing to and hold in a vice which has a hole in it for installing one bearing, theres 2 spanner looking tools the big open end soanner holds the flat sides on the friction plate which the washers go either side of this locks the shaft for doing the nuts at each end.the other spanner looking took holds the toothed gear, the 4 pin tool takes out the oil seal carrier, round cylindrical tool for pressing bearing onto shaft,
07-28-2010, 09:19 PM #3
Go to the Riva site and download the installation instructions for upgrading your supercharger, there should be enough there to get you started....
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By cfnnslsq in forum 4-Tec PerformanceReplies: 4Last Post: 09-13-2007, 03:31 PM
By ph2ocraft in forum Polaris Tech Tips and InfoReplies: 21Last Post: 07-26-2007, 04:07 PM
By RXP Blur in forum 4-Tec PerformanceReplies: 8Last Post: 06-08-2007, 09:12 AM
By ph2ocraft in forum Polaris Open DiscussionReplies: 69Last Post: 09-17-2006, 03:08 PM
By rxpblast in forum Sea Doo Open DiscussionReplies: 9Last Post: 12-22-2005, 05:57 PM