08-03-2010, 10:49 PM #1
- Join Date
- May 2008
STX 1100 With CV Carbs Need Advise Quick!!I have a 1998 Kawasaki STX 1100 Triple with constant velocity carbs on it.
2 of the needles for the slide were bad. By bad I mean the mount on the top which is what holds it in the slide is worn all the way down and the needles just dropped out of the slide.
I have 3 new needles that were off of a 1100 zxi I believe but they are slightly longer
My question is what do you guys think about running them?
being slightly longer will it lean out the ski too much?
what about running washers on the needle to raise it?
The taper on both of the different needles look the same
The number on the needles that were in it is N6PA
The number on the needles I have that are good that I want to try is N7FC
Any advice is greatly appreciated
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By skeletor88 in forum Kawasaki Open DiscussionReplies: 11Last Post: 09-13-2010, 02:06 PM
By emcewin in forum Kawasaki PWC Performance (2-stroke)Replies: 9Last Post: 05-05-2008, 09:31 AM
By daverxp4 in forum Kawasaki PWC Performance (4-stroke)Replies: 12Last Post: 02-06-2008, 07:33 PM
By happyappy in forum Kawasaki Open DiscussionReplies: 0Last Post: 06-13-2007, 03:02 PM
By lil8znguy in forum Kawasaki How To & FAQsReplies: 0Last Post: 05-10-2007, 03:32 PM