Thread: gpr wont crank after rebuild
08-04-2010, 08:36 PM #1
gpr wont crank after rebuild
hey guys im fairly fustrated hear just did a complete rebuild and went to make sure everything turned over properly before putting the pipes on and nothing. i get one faint click then the mfd makes an annoying beeping noise and a red light flashes. then i get no more clicks out of it unless i disconnect and reconnect the battery. the starting system worked fine prior to the rebuild.(3 months ago) so what did i screw up on the install????
08-04-2010, 08:40 PM #2
Will it turn over by hand if you take the plugs out?
08-04-2010, 08:44 PM #3
oh yeah it turns over nice by hand
and i have 12.54 volts on the battery
08-04-2010, 08:48 PM #4
terminals on starter hot/ground tight. Have you tested the starter out of the ski yet?
08-04-2010, 08:58 PM #5
i know the ground is tight ill double check the hot. no i haven't checked the starter out of the ski but it worked fine a few months ago.
08-04-2010, 09:00 PM #6
- Join Date
- Jan 2007
- Milwaukee, Wisconsin, United States
exhaust sensor plugged in or jumped with resistor properly?
tps sensor disconnect throttle cable completely to make sure throttle is all the way closed
08-04-2010, 09:04 PM #7
problem solved slightly loose battery and starter connections
08-04-2010, 09:15 PM #8
Users Browsing this Thread
There are currently 1 users browsing this thread. (0 members and 1 guests)
By boostaholic in forum 4-Tec PerformanceReplies: 12Last Post: 05-30-2008, 09:15 AM
By wfhaynes in forum Yamaha Open DiscussionReplies: 4Last Post: 10-23-2007, 11:04 AM
By Slawter in forum Polaris How To & FAQsReplies: 7Last Post: 06-03-2007, 08:51 AM
By Polaaron in forum Polaris How To & FAQsReplies: 7Last Post: 02-22-2007, 12:38 AM