Results 1 to 3 of 3
  1. #1
    ZIGGY18's Avatar
    Join Date
    Aug 2010
    High Ridge,MO

    Remove motor from gp1300

    Can anyone give me some pointers on how this come out?

  2. #2
    MR-1 X 2's Avatar
    Join Date
    Feb 2007
    Rancho Santa Margarita, CA
    Here you go.

    Most of this should apply even though yours may be a little bit different than the photos.


  3. #3
    Try to use blue painters tape around the opening of the ski so you don't scratch it, and maybe even secure cloths around it. Otherwise everything comes out pretty easily without a fight, except the stinger can be a bitch, but if you you pull the head then it comes right out. Other than that leave the manifold attached, and take the tb's off for the extra clearance. I just hooked a ratcheting come along to the beam in my garage with a chain, then hooked a chain up to each end of the motor and slowly raised it out. You should be able to do it in under 2.5 hours or 3 even for a newb.

Thread Information

Users Browsing this Thread

There are currently 1 users browsing this thread. (0 members and 1 guests)

Similar Threads

  1. gp1300 stepping motor problem
    By xprider02 in forum Yamaha How To & FAQs
    Replies: 10
    Last Post: 06-19-2008, 05:29 PM
  2. differences between 03-04 gp1300 and 05-08 gp1300
    By TDSTYG in forum Yamaha Open Discussion
    Replies: 1
    Last Post: 11-05-2007, 12:41 PM
  3. 2005 gp1300 vs 2006 gp1300 which one to buy?
    By TDSTYG in forum Yamaha PWC Performance (2-stroke)
    Replies: 1
    Last Post: 10-31-2007, 02:15 PM
  4. how do i remove the shaft to motor adapters
    By GameDemon in forum Polaris How To & FAQs
    Replies: 9
    Last Post: 06-25-2007, 12:04 PM
  5. GP1300 05 HP
    By jetsurf in forum Yamaha PWC Performance (2-stroke)
    Replies: 3
    Last Post: 02-08-2006, 10:24 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts